Kitchen & Bath Touch-Up Alpine White
If your bathroom or kitchen surfaces are suffering from a bit of old age or wear and tear, then there can be a cheaper way to restore them to their former glory; rather than gutting your whole bathroom or kitchen space!
This Kitchen & Bath Touch-Up kit from Cramer is perfect for repairing scratches, dents and defects in your bath tub, sink, radiator or taps.
It is easy to apply using the ‘Touch Up’ stick, and is the inexpensive way to patch up your enamel surfaces, cast iron and steel, ceramics, acrylics and fibreglass surfaces.
Heat resistant to 60°C, one coat is usually enough to get the job done and the results are almost invisible to the naked eye! This really is a more cost effective way to get your appliances and surfaces looking as good as new.
|Manufacturer Part Number||Bath Touch-Up|
£10.85 (Inc. VAT)
RRP £21.94 Save 50%
Price Guaranteed For
This product is excellent.It is fine on cookers as heat does not affect it.
Bought this as a last resort to save having to purchase a new sink. Easy to apply, and in my case two coats did the trick - no one realises that removing the old taps had left unsightly black scratches. Have now used it in the bath - one coat covered a small chip, and will no doubt be using it again and again. Excellent product, and good price.
after having a new bath installed we had noticed a small chip on it and did not want the cost/hastle of removing it again so tried this touch up stick. you need to apply a thin layer and re- apply until the layers build up over a few days [allowing to dry in between] .It has hidden the chip really well and am pleased with the result
It was easy to apply and onc dry, it hardly shows up (only if you look for it). Perfect!
IDEAL FOR SMALL REPAIRS NEED TO APPLY SLOWLY DO NOT RUSH IT TAKE YOUR TIME FOR THE BEST RESULTS AND REMEMBER THE TIME LAPSE IN APPLICATION
YOU WILL BE VERY PLEASED WITH THE RESULTS
This product is designed for a small repair, mine was approximately 5mm long by 3mm wide and 1mm deep. It provides an economic solution to retain an existing ceramic sink, especially when a replacement is not available. Requires full drying prior to application, I left it unused for two weeks, I used a hairdryer throughout to speed up the drying process after each minimal application per coat polished off with a pad of toilet tissue to remove any spill on to the surrounding ceramic surface. Total applications were 3 coats [and polish off] a day for a week. leave for a week to fully harden. Has been used for two weeks now with hot water with no apparent degradation
dropped tile in plastic bath, took about 2mm of bath, at bottom of bath, which was brand new. used the product which put the 2mm back, cant even tell,
Good for purpose. Does what it says.