Salus CT100 Cylinder/Pipe Thermostat

The CT100 is a practical surface mounted mechanical thermostat. This thermostat will allow the user to control the temperature of Domestic Hot Water Cylinders (uninsulated and foam lagged).

This unit comes complete with a wire strap which enables the CT100 to be used also as a pipe thermostat. This unit can be used to switch a circulating pump, boiler or most common motorised zone valves.

Installation

Cylinder Thermostat:
The Recommended location is 1/4 to 1/3 up from the bottom of the cylinder. When mounted on foam lagged cylinders, Sufficient area of installation to the depth of the cylinder surface must be removed to allow the thermostat to be in contact with the cylinder.

Pipe Thermostat:
The CT100 pipe thermostat should be located as near to the temperature source to be controlled as possible e.g. not more than 0.6 metres from the boiler.

Features:

• Pipe or Cylinder Thermostat
• Surface Mounted
• Large Dial
• Cable Clamp
• Temperature range between 40°C and 80°C
• Voltage between 220/240V