The new re-designed Mira Excel is the most advanced and versatile mixer shower available in the Mira range. Complete with precise thermostatic control, which recognises and compensates for changes in water pressures and temperatures, it delivers an extremely satisfying water flow rate. Designed to perform to the highest standards both on high and lower pressure systems, the Mira Excel is available in a variety of finishes and configurations offering flexible showering solutions for the whole family.

• Independent selection of temperature and easy lever operation for spray force
• Thermostatic control prevents any sudden temperature changes
• Maximum temperature stop prevents selection of an unsafe temperature, which can be over-ridden by the use of a discreet push button
• Ceramic plate technology resists limescale build up in hard water areas
• Supplied with Mira Logic shower fittings - including 4 mode easy clean handset featuring Start, Soothe, Force, and Eco spray patterns
• Large accessible filters which even if 50% blocked have unaffected performance
• 5 Year Manufacturer's Guarantee
• All Mira Logic riser rails have an indent at one end of the rail to ease installation - this is not a fault

Plumbing system compatibility:

• Gravity fed hot and cold water supplies
• Gravity fed hot and cold supplies - both pumped
• Fully modulating combination boilers and instantaneous gas water heaters
• Mains pressure hot and cold - unvented
• Mains pressure thermal store
• Compatible for use with exposed rise and fall pipework

What are the centre dimensions for this shower? Are the inlet pipes 15mm?
The inlet centers can be set at 150 – 155 mm

Is this unit a direct replacement for a mira 415
You would need to check the dimensions these can be found on the link below
http://www.plumbworld.co.uk/mira-excel-thermostatic-1431-15215/2
 
Are the inlet pipes 15mm?
The inlet connections would be 15 mm

What does EV mean
This refers to Exposed Valve

Is this compatible with an combination boiler?
Yes this should be compatible

Is this compatible with gravity fed systems?
Yes this should be compatible with a gravity fed system you would require a 0.1 bar pressure

What is the difference between surface mounted & recessed?
Surface mounted would be on the outside of the wall and recessed would be installed through the wall, usually using a face plate

Have you any dimensions for this shower valve ?
The dimensions can be found on this link http://www.plumbworld.co.uk/mira-excel-thermostatic-1431-15215/2

Have you the installation instructions?
The installation instructions can be found on this link http://www.mirashowers.com/onlinecatalog/pdf/p3840_4.pdf

Alternatives