Danfoss 2 Channel Full Programmer FP715Si

The FP715 two-channel full programmer has separate Heating and Hot Water outputs operating on completely independent time bases for maximum flexibility.

The FP715 can be configured by the installer at time of installation to provide 7 day, 24 hour, or 5 day/2 day operation and to provide either 2 ON/OFF's or 3 ON/OFF's per day, allowing the time control to be tailored to match the specific requirement of the consumer.

Additionally the programmer can be set for either 'pumped' or 'gravity' hot water.

The wallplate used follows the industry standard pattern, as used by many of the other time control Manufacturer's. This allows for direct replacement often without the need for re-wiring.

An additional range of accessories allow the FP715 to be used in other upgrade situations where the unit being replaced is larger than the new unit and a decoration scar would normally have been left.

Additional features such as convenient user overrides, built-in ready-to-use programmes, a day programme copy facility as well as a stylish, compact design and easy to read display make the FP715 the simple answer to all heating and hot water requirements.

• Two channel full programmer
• 7 day, 24 hour or 5/2 day, selectable at installation
• 2 On/Offs or 3 On/Offs per day, selectable at installation
• Pumped or gravity hot water operation, selectable at installation
• Independent HW & CH output channels
• On/Off.Auto.Allday selectable programmes
• Factory pre-set On/Off time
• Advanced override per channel
• +1 hour override per channel
• 24 hours minimum Lithium battery backup
• 45°C Max ambient temperature
• Dimensions: 135 W x 88 H x 32mm D